The store will not work correctly in the case when cookies are disabled.
We use cookies to make your experience better.To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Replacement EKG Wrist Straps. For wrist to wrist EKG/ECG placement. Can be used with any three snap lead cable. Designed specifically for use with the Thought Technology T9306M EKG sensor kit. Learn More
The Voltage Isolator 4 Infiniti is an interface device which provides electrical isolation. It will allow Thought Technologys systems to be safely interfaced with analog outputs of line-powered systems, such as computers with DAC cards, isokinetic dynamometers, or force platforms. Learn More
Bend Sensor is small enough to be placed on fingers and wrists to monitor joint motion. 180 degrees of flexion. Use sensors back to back to get a 360 degree range. Learn More
ProComp Infiniti Heart Rate/BVP (SA9308M)sensor & cable is 48 inches (122.5 cm) in length and is terminated in a small plastic enclosure which houses both the Photodetector and LED. Used with Thought Technology ProComp Plus, ProComp Infiniti, ProComp 2, Procomp5, or Flexcomp series systems. Learn More
The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More
The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More
Used ProComp+ Heart Rate/BVP cable is 48 inch (122.5 cm) in length and is terminated in a small plastic enclosure which houses both the Photodetector and LED. Learn More
The Myoscan-Pro v2 (SA9401M-60) surface EMG sensor consists of 3 snap style receptacles - 2 active (positive & negative) and 1 reference (ground). Learn More
This EEG lead kit allows users to make either monopolar or bipolar single channel measurements. 1.5 mm DIN Connector to disc. Sintered silver/silver-chloride (Ag/AgCl) EEG electrodes and ear clips for DC and low frequency EEG applications. Cable is appox 40" in length. Learn More
EEG-Z3 is a pre-amplified electroencephalograph sensor with built in impedance checking and 3 modes of operation: regular EEG mode (above 2 Hz), low frequency mode (above 0.01 Hz) for evoked potentials (EP) and low frequency applications and DC mode for true DC operation (above 0 Hz) for slow cortical potentials (SCP). Learn More