Accessories

Filter
Set Descending Direction

215 items

per page
View as List Grid
  1. DC-EEG Monopolar/Bipolar Kit
    This EEG lead kit allows users to make either monopolar or bipolar single channel measurements. 1.5 mm DIN Connector to disc. Sintered silver/silver-chloride (Ag/AgCl) EEG electrodes and ear clips for DC and low frequency EEG applications. Cable is appox 40" in length. Learn More
    $215.00
  2. EEG-Z3 Sensor
    EEG-Z3 is a pre-amplified electroencephalograph sensor with built in impedance checking and 3 modes of operation: regular EEG mode (above 2 Hz), low frequency mode (above 0.01 Hz) for evoked potentials (EP) and low frequency applications and DC mode for true DC operation (above 0 Hz) for slow cortical potentials (SCP). Learn More
    $595.00
  3. E4S Electro-Cap Quick Insert Electrode
    The E4S Quick insert electrode is a temporary electrode which will override the cap wiring in the event of a faulty electrode during a test. A Quick Insert Electrode may be placed into the mount of the faulty electrode and connected directly to the EEG machine until the cap can be properly repaired. Learn More
  4. Used TT-EEG Gold Cup Cable - Blue
    The Thought Technology SA9323 is a single gold EEG cup electrode on one end with a 1.5mm (.060) DIN connection on the other. This gold EEG cup lead can be used with any standard DIN cable. Approximately 18" in length. Learn More
    $15.00
  5. Used TT-EEG Gold Cup Cable
    The Thought Technology SA9323 is a single gold EEG cup electrode on one end with a 1.5mm (.060) DIN connection on the other. This gold EEG cup lead can be used with any standard DIN cable. Approximately 18" in length. Learn More
    $15.00
  6. EEG Expert QIK Test
    Neurofeedback Performance Tracking and Report Generator Stand alone battery powered test device allowing unmatched accuracy On-line analysis and reports from EEG Expert Pre-post CPT and session-by-session performance tracking. Learn More
    $950.00
  7. Remote Finger Sensor For GSR2
    Remote Finger Sensor for GSR 2. Plugs into the side of the GSR 2 to allow for use of two finger sensors. Learn More
    $36.00
  8. Round On Both Ends Protected Pin Replacement Sensor Cable
    Replacement cable for round pin connection to round protected pin encoders. 60 inches long. Learn More
    $45.00
  9. J&J Input Extension Cable
    Input extender for the J&J C2+ 12 channel and 6 channel systems. Learn More
    $40.00
  10. Plastic EEG Ear Clips - 2 pack
    EEG Ear clip with 17mm Silver Silver Chloride pellet sensor - use with J+J Engineering I-330 systems or any snap cable. Learn More
Filter
Set Descending Direction

215 items

per page
View as List Grid