Biofeedback Equipment Accessories

MyOnyx EMG/Stim Cable

MyOnyx EMG/Stim Cable For Use with MyOnyx - Portable and Wireless - EMG and Electrostimualation Devices Learn More

$55.00

Rectal Sensor - Emg & Stim

The St-Cloud/Femelex electrodes are used vaginally or in the rectum to stimulate or sense the pelvic floor muscles. Cables terminate in two din connections. Learn More

$72.00 As low as $64.80

Vaginal Sensors - Stim & EMG

These electrodes are used vaginally to stimulate or sense the pelvic floor muscles. For use with the Myonx EMG system. Learn More

$60.00 As low as $54.00

Voltage Isolator 4

The Voltage Isolator 4 Infiniti is an interface device which provides electrical isolation. It will allow Thought Technologys systems to be safely interfaced with analog outputs of line-powered systems, such as computers with DAC cards, isokinetic dynamometers, or force platforms. Learn More

$720.00

Neurofield Power Supply for X3000 or Q20

Neurofield power supply (one needed for each box. (The Q20 can also be placed on battery). Learn More

$375.00

Bend Sensor with Adapter - SA9550

Bend Sensor is small enough to be placed on fingers and wrists to monitor joint motion. 180 degrees of flexion. Use sensors back to back to get a 360 degree range. Learn More

$295.00

Used Thought Technology EEG Gold Ear Clip - Yellow

The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More

$20.00

Used Thought Technology EEG Gold Ear Clip - Black

The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More

$20.00

DC-EEG Monopolar/Bipolar Kit

This EEG lead kit allows users to make either monopolar or bipolar single channel measurements. 1.5 mm DIN Connector to disc. Sintered silver/silver-chloride (Ag/AgCl) EEG electrodes and ear clips for DC and low frequency EEG applications. Cable is appox 40" in length. Learn More

$215.00

EEG-Z3 Sensor

EEG-Z3 is a pre-amplified electroencephalograph sensor with built in impedance checking and 3 modes of operation: regular EEG mode (above 2 Hz), low frequency mode (above 0.01 Hz) for evoked potentials (EP) and low frequency applications and DC mode for true DC operation (above 0 Hz) for slow cortical potentials (SCP). Learn More

$595.00

Mon-Fri 9AM-5PM EST

Accessories

CONTACT INFO

Customer Service

Customer Care