Accessories

Filter
Set Descending Direction

215 items

per page
View as List Grid
  1. Vaginal Sensors - Stim & EMG
    These electrodes are used vaginally to stimulate or sense the pelvic floor muscles. For use with the Myonx EMG system. Learn More
  2. Pro SB Converter / RS232
    The SA8950 is the component that the fiber optic cables uses to connect to the serial port for the ProComp+ encoder or Procomp 2 system. Learn More
    $500.00
  3. Voltage Isolator 4
    The Voltage Isolator 4 Infiniti is an interface device which provides electrical isolation. It will allow Thought Technologys systems to be safely interfaced with analog outputs of line-powered systems, such as computers with DAC cards, isokinetic dynamometers, or force platforms. Learn More
    $720.00
  4. Used 1M2F Y-Connector
    Used SA9315 connects a single electrode to two inputs. Allows use of the same electrode in two channels for common ground or reference. Learn More
    $12.00
  5. Bend Sensor with Adapter - SA9550
    Bend Sensor is small enough to be placed on fingers and wrists to monitor joint motion. 180 degrees of flexion. Use sensors back to back to get a 360 degree range. Learn More
    $295.00
  6. Skin Conductance Sensor
    Skin Conductance sensor (SA9309M) for use with Thought Technology ProComp Plus, ProComp Infiniti, ProComp 2 or 5, or FlexPro series systems. Learn More
    $355.00
  7. Used Thought Technology EEG Gold Ear Clip - Black
    The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More
    $20.00
  8. Used Thought Technology EEG Gold Ear Clip - Yellow
    The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More
    $20.00
  9. Monopolar / Bipolar EEG Electrode Kit - Thought Technology
    The T8750 EEG Electrode kit has DIN style EEG leads with DIN cable for the Thought Technology EEG Sensors. Includes cables for both Monopolar and Bipolar EEG placements. Includes (2) Gold Ear Clips and (2) Cup sensors - 22.5" in length and T8740 DIN Cable. Learn More
    $210.00
  10. Switch Sensor Cable for ProComp 2 with EEG-Z Sensor
    The switch sensor cable enables you to trigger an impedance check with the EEG-Z sensor by pressing and releasing the switch button to briefly interrupt the sensor circuit. The EEG-Z sensor enters impedance checking mode, without requiring you to disconnect and reconnect the sensor. Learn More
    $60.00
Filter
Set Descending Direction

215 items

per page
View as List Grid