The store will not work correctly in the case when cookies are disabled.
We use cookies to make your experience better.To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Use the 1089NP to rapidly check applied electrode contact impedance of multiple EEG electrode configurations. Ideal for electrode configurations found in Cranial EEG caps. This EEG impedance meter has a 25 pin connector for Electro-Cap 19 channel cap connection. Learn More
The UFI 1089ES all you to rapidly check applied electrode contact impedance of multiple electrode configurations. Ideal for electrode configurations found in Cranial EEG caps. Has 25 pin connector for Electro-Cap 19 channel cap connection. Learn More
The 1089 Mark III EEG impedance meter provides quick and easy evaluation of total electrode contact impedance and offset voltage between two electrodes. Learn More
The Voltage Isolator 4 Infiniti is an interface device which provides electrical isolation. It will allow Thought Technologys systems to be safely interfaced with analog outputs of line-powered systems, such as computers with DAC cards, isokinetic dynamometers, or force platforms. Learn More
For use with the BrainMaster 2E. Take multiple electrode readings without errors, changing electrodes, or moving pins. Easy to use for small EEG assessments. offering an alternative to manual assessments. Learn More
Bend Sensor is small enough to be placed on fingers and wrists to monitor joint motion. 180 degrees of flexion. Use sensors back to back to get a 360 degree range. Learn More
The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More
The Though Technology SA9321 is a single gold EEG ear clip electrode on one end with a 1.5mm (.060) DIN connection on the other end. For use with the T8740 DIN Cable or and standard DIN socket. Approximately 18" in length. Learn More
This EEG lead kit allows users to make either monopolar or bipolar single channel measurements. 1.5 mm DIN Connector to disc. Sintered silver/silver-chloride (Ag/AgCl) EEG electrodes and ear clips for DC and low frequency EEG applications. Cable is appox 40" in length. Learn More
EEG-Z3 is a pre-amplified electroencephalograph sensor with built in impedance checking and 3 modes of operation: regular EEG mode (above 2 Hz), low frequency mode (above 0.01 Hz) for evoked potentials (EP) and low frequency applications and DC mode for true DC operation (above 0 Hz) for slow cortical potentials (SCP). Learn More