The store will not work correctly in the case when cookies are disabled.
We use cookies to make your experience better.To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
The 1089 Mark III EEG impedance meter provides quick and easy evaluation of total electrode contact impedance and offset voltage between two electrodes. Learn More
These plastic molded GSR finger clips with sintered Silver/Silver Chloride (Ag/AhCl) electrodes make it quick and easy to start recording GSR signals. Consistent pressure is applied for a cleaner signal. No more itchy hook and loop finger bands that come loose or slip off. Learn More
These caps have the same electrode layout as the Electro-Caps, but have a connector that allows them to connect directly to the Cadwell Easy2 and Cadwell Easy3 equipment. They also come with cap straps, which can be replaced with chin straps upon request.
Disposable Sponge Disks for Electro-Caps (pkg. of 100) Part # E6. Foam circles with adhesive backing used on the forehead or on any other hairless areas. The sponge disks are approx 1 1/4 inch round and the center hole is a bit bigger than 1/4 inch. Learn More
Specially designed ear clips typically used with Lexicor style Electro-cap with ear leads. 3 1/2 inch DIN Style EEG ear clips. For Lexicor style Electro-caps with ear leads. Standard 1.5mm DIN socket. This short ear lead plugs into the DIN socket on the cap. These are the "old style" lead with a soft rubber backing. Learn More
DIN style gold EEG leads for DIN Cable. Includes DIN style leads for both Monopolar and Bipolar EEG placements. Includes (2) Gold Ear Clips and (2) Gold Cup sensors - Approximately 22.5" in length. Terminated with a 1.5mm (.060) DIN safety plug. Learn More
Specially designed ear clips typically used with Lexicor style Electro-cap with ear leads. 3 1/2 inch DIN Style EEG ear clips. For Lexicor style Electro-caps with ear leads. Standard 1.5mm DIN socket. This short ear lead plugs into the DIN socket on the cap. Learn More
The SA9503M surface EMG sensor consists of a triangular shape sensor head (SA9503M) with 3 snap style receptacles representing 2 active (positive & negative) electrodes and 1 reference (ground) electrode. Learn More